Page 1 of 1

Lambert Conic Projection Map Parameters...

Posted: Tue May 31, 2005 1:27 am
by Guest
Good day,

I'm trying to calibrate a VNC aero navigation chart, I am having difficulty understanding what to put in the projection parameters section of the map converter. The projection of the map is Lambert Conic Projection When I leave the projection parameters blank I get a projlib error 21 in the palm os.

Any help would be apreciated.

Thanks, Dave.

Posted: Tue May 31, 2005 7:27 pm
by Scott
Can you post one of the maps as a sample? LCC parameters are based on the layout of the map.

Posted: Wed Jun 01, 2005 10:51 pm
by Guest
Attached is the scanned section of the VNC and the prc file with calibration points.

Posted: Wed Jun 01, 2005 10:56 pm
by Guest
Attachement didn't take for some reason?

I'll try again...with just the jpg..